Szabványkereső

Hivatkozási szám, azonosítójelzet, vagy a szabványcímben előforduló kulcsszó szerinti keresés:

Keresés / szűrés:

Érvényes szabványok megjelenítése | Visszavont szabványok megjelenítése

ICS (a szabványok nemzetközi osztályozási rendszere) szerinti keresés


Alapadatok
Dokumentumazonosító 163793
Hivatkozási szám MSZ EN 301 447:2016
Cím Műholdas földi állomások és rendszerek (SES). A 2014/53/EU irányelv 3. cikke (2) bekezdésének alapvető követelményeit tartalmazó, harmonizált szabvány a műholdas állandó helyű szolgálat (FSS) számára felosztott 4/6 GHz-es frekvenciasávokban működő, hajók fedélzetén elhelyezett műholdas földi állomások (ESV-k) számára
Angol cím Satellite Earth Stations and Systems (SES). Harmonised Standard for satellite Earth Stations on board Vessels (ESVs) operating in the 4/6 GHz frequency bands allocated to the Fixed Satellite Service (FSS) covering the essential requirements of article 3.2 of the Directive 2014/53/EU
ICS 33.060.30 Közvetítő rádióállomások és állandó, műholdas kommunikációs rendszerek
33.070.40 Műholdak
A szabvány nyelve angol
Alkalmazási terület The present document applies to Earth Stations located on board Vessels (ESVs) which have the following characteristics: • The ESV is comprised of all the equipment, electrical and mechanical, from the antenna itself to the interface with other communications equipment on board (usually referred to as the terrestrial interface). • The ESV transmits in the frequency range from 5 925 MHz to 6 425 MHz allocated to the Fixed Satellite Services (FSS) (earth-to-space). • The ESV receives in one or more frequencies within the range from 3,700 GHz to 4,200 GHz in the bands allocated to the Fixed Satellite Services (FSS) (space-to-earth), depending on the ITU Region where the ESV is located. • The ESV transmits a single carrier. • The ESV uses linear or circular polarization. • The ESV operates through a geostationary satellite at least 2° to 3° away from any other geostationary satellite operating in the same frequency band and covering the same area. NOTE 1: The satellite spacing is mainly equal to 3° in ITU Regions 1 and 3 and 2° in ITU Region 2. The ESV transmits at elevations greater or equal to the minimum elevation angle declared by the applicant. • The ESV antenna diameter is not smaller than 2,4 m. • The ESV is designed for transmission and reception of radio-communications signals in accordance with any of the frequency bands specified above. • The ESV is usually designed for unattended operation. • The ESV is operating as part of a satellite network (e.g. star, mesh or point-to-point) used for the distribution and/or exchange of information between users. • The ESV is controlled and monitored by a Network Control Facility (NCF). The NCF is outside the scope of the present document. The present document applies to the ESV with its ancillary equipment and its various telecommunication ports, and when operated within the boundary limits of the operational environmental profile declared by the applicant and when installed as required by the applicant by declaration or in the user documentation. The present document is intended to cover the provisions of Directive 2014/53/EU [7] (RE Directive) article 3.2, which states that "… radio equipment shall be so constructed that it both effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference". The present document incorporates the technical limitations listed in annex 2 of ITU-R Resolution 902 (WRC-03) [i.1], ECC Report (05)69 [i.2], and ECC Report (06)91 [i.3]. NOTE 2: According to ITU-R Resolution 902 [i.1], any transmission from ESVs within the 300 km minimum distance of each country where the ESV transmit frequency band is used by the Fixed Service will be subject to the prior agreement of the concerned administration(s), which may specify additional operational requirements, or to the relevant ECC Decision. In addition to the present document, other ENs that specify technical requirements in respect of essential requirements under other parts of article 3 of the Directive 2014/53/EU [7] may apply to equipment within the scope of the present document. NOTE 3: A list of such ENs is included on the web site http://www.newapproach.org/.
Az érvényesség kezdete 2016-10-01
A visszavonás napja

További adatok
Forrás idt EN 301 447:2016-05
Helyettesített szabvány(ok) MSZ EN 301 447:2008
Helyettesítő szabvány(ok)
Módosítás(ok)
(külön szabványként)
SZK-közlemények
Kapcsolódó európai jogszabály
Műszaki Bizottság MSZT/MB 850

Kereskedelmi adatok
A szabvány
kapható formátuma papír,
PDF-fájl (a fájl mérete: 474992 byte)
oldalszáma 66 oldal; V kategória
ára Nettó: 13900 Ft
Bruttó:
papírformátum esetén (5% Áfával): 14595.0 Ft
elektronikus (PDF-) formátum esetén (27% Áfával): 17653.0 Ft